20 Fun Informational Facts About Nissan Qashqai Key Fob

Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai has a distinct SUV-like feel due to its larger dimensions. Additionally, the ride on 19-inch wheels in Ti and ST-L models can be a bit stiff at times. The front tyres of the Qashqai could also lose grip on bumpy surfaces, and the CVT could occasionally display a wrist-flexing torque steering.

This is typically caused by an unresponsive battery, which can be replaced in just a few minutes. Make sure the new battery is of the same voltage, size and specifications.

Water Damage

Water damage is among the most common causes that cause an Nissan keyfob to display the "key ID is incorrect" message. The key fob has rubber seals that shield the electronic chip inside. However, prolonged exposure to moisture can cause it to cease functioning properly. This is typically the case when you've dropped your key fob in the ocean or into a swimming pools, but it could also happen if it gets wet due to soapy hands or rain.

If your key fob is exposed to water for a long period of time, it might need to be cleaned using isopropyl alcohol or electronic cleaner. Or, it could require the attention of an expert for repair or replacement.

If your key fob needs to be replaced, it's an easy process. Make sure you have the correct multipack (CR2032, 3V). Unlock the front and rear cases using a flathead screwdriver. You'll have to remove the clips that hold the metal together and pull out the battery that was in place, and then put in the new one. Reassemble the fob and replace the mechanical key. Make sure it's working properly. If not then you'll need to take it to an Nissan dealer or professional auto locksmith to replace the key chip. Fortunately, the chip is not typically damaged by exposure to water and therefore this shouldn't be too expensive.

Dead Coin Battery

The coin battery is another common reason why your Nissan Qashqai remote key fob might not function. The batteries typically last for 3-5 years, but they can become depleted over time, particularly if the fob is frequently dropped. You could replace the battery however, make sure it's the same voltage and same size as the original. If you are using a different battery it may cause the key to have an invalid key ID which could prevent it from paired with your vehicle.

The best way to change the battery of a coin in a Nissan Qashqai Key Fob is to pry it open with the help of a small screwdriver with a flat head. The screwdriver needs to be inserted into a small notch on the bottom of the key fob. The screwdriver should be gently twisted to break the two halves. Remove the old CR2025 battery and replace it with a new one, making note of the position of the old one within the fob.

Examine  G28CarKeys  for dirt or water damage prior to installing the new battery. If there is, clean the terminals with a tiny amount of isopropyl alcohol. Make sure that the pole cables are connected correctly. They should be connected to the positive and negative poles of your battery.

Troubleshooting

If your Nissan Qashqai's key fob isn't working after exposure to clean tap or rain water, this could indicate that there's an issue with the internal chip. A battery change won't solve the issue, and you'll need to purchase the new key fob. If the key fob has stopped working after dropping it, it's likely that the chip inside was damaged. You can usually get the key fob to work again if you remove and clean the chip using paper towel and isopropyl alcohol and then put it back in.

One common error you may notice on your car's dashboard is "Key ID Not Correct." This means that the car cannot recognize the key fob and will not allow it to start the engine. This can happen in various ways, including water damage, problems that are undetectable in the circuitry of the key fob or RFID interference.

If the battery that powers 12 volts on your key fob is broken or is not supplying enough electrical current it will cease to function. This can affect the remote keyless system and central locking on your Nissan Qashqai, as well as making it impossible to start your engine with the key fob (if equipped with Intelligent Key). Check the batteries inside the key fob if it is unable to lock or unlock your door by hand. You may also try reinserting the battery to reset the transmitter.

Reprogramming

If the key fob has not been submerged in salt water the device should be able to be revived after a simple wash with clean water. You can also try cleaning the electronic chip with isopropyl alcohol or an electronic cleaner. If none of these works it is possible to replace the key fob.

If your Nissan Intelligent Key is still not working, it could be a problem with the connection between it and the car. Start by pressing the ignition key, but without initiating the vehicle. Continue to do this until the hazard light blinks twice. After that, turn the car off and take the keys out.

Then, open the fob compartment in your vehicle. It's usually on a door's jamb or the handle for the driver's door. Find the small "program" button and press it. Once the process has been completed you will hear an audible sound.

Now that your Intelligent Key is relinked to the car It's time to test it out. Set your feet a distance from the vehicle, then press all the buttons on the key. If the lights flash and the horn sound, it means that the key is successfully linked to the Nissan. You can also test it close to the Nissan.